Heavy-duty galvanised steel
U-pins — the right fastener for synthetic turf installed on soft sub-bases
(soil, compost, existing lawn, crushed rock with fines). The U-shape spreads
load over two prongs, so it holds firm without pulling through, and sits low
enough to disappear under the turf blades.
Key features
- Heavy-duty galvanised steel — rust-resistant and built
to last
- U-shape design spreads load and grips soft ground
better than straight nails
- 50 pack — enough to secure a typical small residential
job
- Low-profile crown sits below pile height
- Paired with our joining tape for a complete install kit
Best for
- Soft sub-bases — soil, compost, established lawns
- Perimeter securing on garden-bed edges and borders
- Weed-matting and geotextile pinning
- Anywhere a spiralised nail would simply push through
Specifications
Product Specifications
|
Detail
|
Specification
|
|
Type
|
HD U-pin
(two-prong)
|
|
Material
|
Galvanised
steel
|
|
Pack
size
|
50 pieces
|
|
Recommended
spacing
|
300–400 mm
along edges; closer on high-wear areas
|
Installation tip
Push pins in by hand first to
set the line, then drive home with a mallet until the crown is flush with the
backing. For installs that cross from soft ground onto a paved or compacted
edge, switch from U-pins to spiralised nails at the transition point.
Further reading
•
How
to lay artificial turf — a step-by-step guide
Stock can vary by location — we cut and deliver
within 1–3 working days if not in stock at your local store.
